This apprenticeship has options. This document is currently showing the following option:
V1.1
This document explains the requirements for end-point assessment (EPA) for the cleaning hygiene operative apprenticeship. End-point assessment organisations (EPAOs) must follow this when designing and delivering the EPA.
Cleaning hygiene operative apprentices, their employers and training providers should read this document.
This is a core and options apprenticeship. An apprentice must be trained and assessed against the core and one option. The options are:
A full-time cleaning hygiene operative apprentice typically spends 12 months on-programme. The apprentice must spend at least 12 months on-programme and complete the required amount of off-the-job training in line with the apprenticeship funding rules.
The EPA should be completed within an EPA period lasting typically 3 months.
The apprentice must complete their training and meet the gateway requirements before starting their EPA. The EPA will assess occupational competence.
An approved EPAO must conduct the EPA for this apprenticeship. Employers must select an approved EPAO from the apprenticeship provider and assessment register (APAR).
This EPA has 3 assessment methods.
The grades available for each assessment method are below.
Assessment method 1 - knowledge test:
Assessment method 2 - observation with questioning:
Assessment method 3 - interview:
The result from each assessment method is combined to decide the overall apprenticeship grade. The following grades are available for the apprenticeship:
The EPA is taken in the EPA period. The EPA period starts when the EPAO confirms the gateway requirements have been met and is typically 3 months.
The EPAO should confirm the gateway requirements have been met and the EPA should start as quickly as possible.
The apprentice’s employer must confirm that they think their apprentice is working at or above the occupational standard. The apprentice will then enter the gateway. The employer may take advice from the apprentice's training provider(s), but the employer must make the decision.
The apprentice must meet the gateway requirements before starting their EPA.
These are:
The apprentice must submit any policies and procedures as requested by the EPAO.
The assessment methods can be delivered in any order.
The result of one assessment method does not need to be known before starting the next.
In the knowledge test, the apprentice answers questions in a controlled and invigilated environment. It gives the apprentice the opportunity to demonstrate the knowledge mapped to this assessment method.
This assessment method is being used because the occupation requires the ability to recall from memory the underpinning knowledge in relation to health and safety, legislation, and procedures. A multiple-choice knowledge test is an effective and cost-efficient method of assessing this ability.
The knowledge test must be structured to give the apprentice the opportunity to demonstrate the knowledge mapped to this assessment method to the highest available grade.
The test can be computer or paper based.
The test will consist of 24 multiple-choice questions.
Multiple-choice questions must have four options, including one correct answer.
The apprentice must be given at least 14 days’ notice of the date and time of the test.
The apprentice must have 50 minutes to complete the test.
The test is closed book which means that the apprentice cannot refer to reference books or materials whilst taking the test.
The test must be taken in the presence of an invigilator who is the responsibility of the EPAO. The EPAO must have an invigilation policy setting out how the test must be conducted. It must state the ratio of apprentices to invigilators for the setting and allow the test to take place in a secure way.
The EPAO must verify the apprentice’s identity and ensure invigilation of the apprentice for example, with 360-degree cameras and screen sharing facilities.
The EPAO is responsible for the security of the test including the arrangements for on-line testing. The EPAO must ensure that their security arrangements maintain the validity and reliability of the test.
The test must be marked by an independent assessor or marker employed by the EPAO. They must follow a marking scheme produced by the EPAO. Marking by computer is allowed where question types support this.
A correct answer gets 1 mark.
Any incorrect or missing answers get zero marks.
The EPAO is responsible for overseeing the marking of the test. The EPAO must ensure standardisation and moderation of tests with written answers.
The apprentice must take the test in a suitably controlled and invigilated environment that is a quiet room, free from distractions and influence. The EPAO must check the venue is suitable.
The test could take place remotely if the appropriate technology and systems are in place to prevent malpractice.
Question and resource development
The EPAO must develop a purpose-built assessment specification and question bank. It is recommended this is done in consultation with employers of this occupation. The EPAO should maintain the security and confidentiality of EPA materials when consulting with employers. The assessment specification and question bank must be reviewed at least once a year to ensure they remain fit-for-purpose.
The assessment specification must be relevant to the occupation and demonstrate how to assess the KSBs mapped to this assessment method. The EPAO must ensure that questions are refined and developed to a high standard. The questions must be unpredictable. A question bank of sufficient size will support this.
The EPAO must ensure that the apprentice has a different set of questions in the case of re-sits or re-takes.
The EPAO must produce the following materials to support the test:
The EPAO must ensure that the EPA materials are subject to quality assurance procedures including standardisation and moderation.
In the observation with questions, an independent assessor observes the apprentice in their workplace and asks questions. The apprentice completes their day-to-day duties under normal working conditions. Simulation is not allowed. It gives the apprentice the opportunity to demonstrate the KSBs mapped to this assessment method.
This assessment method is being used because:
The observation with questioning must be structured to give the apprentice the opportunity to demonstrate the KSBs mapped to this assessment method to the highest available grade.
An independent assessor must conduct and assess the observation with questioning.
The independent assessor must only observe one apprentice at a time to ensure quality and rigour. They must be as unobtrusive as possible.
The EPAO must give the apprentice 14 days' notice of the observation with questions.
The observation must take 2 hours.
The independent assessor can increase the time of the observation with questions by up to 10%. This time is to allow the apprentice to complete a task or respond to a question if necessary.
The observation with questions cannot be split, except for comfort breaks or to allow the apprentice to move from one location to another. Such breaks will not count towards the total observed time.
The EPAO must manage invigilation of the apprentice during the assessment, to maintain security of the EPA, in line with their malpractice policy. This includes breaks and moving between locations.
The independent assessor must explain to the apprentice the format and timescales of the observation with questions before it starts. This does not count towards the assessment time.
The independent assessor should observe the following during the observation:
The apprentice must be observed in their usual working environment, performing their daily cleaning schedules. It is expected the apprentices normal cleaning schedules will allow the apprentice to demonstrate their cleaning skills against the KSBs, supplemented by some questions when required.
These activities provide the apprentice with the opportunity to demonstrate the KSBs mapped to this assessment method.
The independent assessor must ask questions.
The purpose of the questions is to clarify further, any elements of a KSB, so as to allow the apprentice to demonstrate their full comprehension of the theme being performed.
Questioning can occur during the observation. The time for questions asked during the observation is included in the overall assessment time. The independent assessor must ask at least 5 questions during the observation. To remain as unobtrusive as possible, the independent assessor should ask questions during natural stops between tasks rather than disrupting the apprentice’s flow. Follow-up questions are allowed where clarification is required. The independent assessor must use the questions from the EPAO’s question bank.
The independent assessor must ask questions about KSBs that were not observed to gather assessment evidence. These questions are in addition to the set number of questions for the observation with questions and should be kept to a minimum.
The observation must be terminated if at any time during the assessment the independent assessor observes unsafe practice. In these circumstances, the apprentice will be awarded a fail grade.
The independent assessor must make the grading decision. The independent assessor must assess the observation and responses to questions holistically when deciding the grade.
The independent assessor must keep accurate records of the assessment. They must record:
The observation with questioning must take place in the apprentice’s normal place of work for example, their employer’s premises or a customer’s premises. Equipment and resources needed for the observation must be provided by the employer and be in good and safe working condition.
Questioning that occurs after the observation should take place in a quiet room, free from distractions and influence.
The EPAO must develop a purpose-built assessment specification and question bank. It is recommended this is done in consultation with employers of this occupation. The EPAO should maintain the security and confidentiality of EPA materials when consulting with employers. The assessment specification and question bank must be reviewed at least once a year to ensure they remain fit-for-purpose.
The assessment specification must be relevant to the occupation and demonstrate how to assess the KSBs mapped to this assessment method. The EPAO must ensure that questions are refined and developed to a high standard. The questions must be unpredictable. A question bank of sufficient size will support this.
The EPAO must produce the following materials to support the observation with questioning:
The EPAO must ensure that the EPA materials are subject to quality assurance procedures including standardisation and moderation.
In the interview, an independent assessor asks the apprentice questions. It gives the apprentice the opportunity to demonstrate the KSBs mapped to this assessment method.
This assessment method is being used because it is an appropriate method for the knowledge, skills and behaviours, which cannot be reliably assessed in the other chosen assessment methods in the plan.
The interview must be structured to give the apprentice the opportunity to demonstrate the KSBs mapped to this assessment method to the highest available grade.
An independent assessor must conduct and assess the interview.
The purpose is to assess the apprentice’s competence against the following themes:
The EPAO must give an apprentice 14 days' notice of the interview.
The interview must last for 30 minutes. The independent assessor can increase the time of the interview by up to 10%. This time is to allow the apprentice to respond to a question if necessary.
The independent assessor must ask at least 5 questions. The independent assessor must use the questions from the EPAO’s question bank.
The independent assessor must make the grading decision.
The independent assessor must keep accurate records of the assessment. They must record:
The interview must take place in a suitable venue selected by the EPAO for example, the EPAO’s or employer’s premises.
The interview should take place in a quiet room, free from distractions and influence.
The EPAO must develop a purpose-built assessment specification and question bank. It is recommended this is done in consultation with employers of this occupation. The EPAO should maintain the security and confidentiality of EPA materials when consulting with employers. The assessment specification and question bank must be reviewed at least once a year to ensure they remain fit-for-purpose.
The assessment specification must be relevant to the occupation and demonstrate how to assess the KSBs mapped to this assessment method. The EPAO must ensure that questions are refined and developed to a high standard. The questions must be unpredictable. A question bank of sufficient size will support this.
The EPAO must ensure that the apprentice has a different set of questions in the case of re-sits or re-takes.
The EPAO must produce the following materials to support the interview:
The EPAO must ensure that the EPA materials are subject to quality assurance procedures including standardisation and moderation.
Performance in the EPA determines the apprenticeship grade of:
An independent assessor must individually grade the: observation with questioning and interview in line with this EPA plan.
The EPAO must combine the individual assessment method grades to determine the overall EPA grade.
If the apprentice fails one or more assessment methods, they will be awarded an overall fail.
To achieve an overall pass, the apprentice must achieve at least a pass in all the assessment methods. To achieve an overall EPA distinction, the apprentice must achieve a pass in the Knowledge test and a distinction in the Observation with questions and the Interview.
Grades from individual assessment methods must be combined in the following way to determine the grade of the EPA overall.
If the apprentice fails one or more assessment method, they can re-sit or a re-take at their employer’s discretion. The apprentice’s employer needs to agree that a re-sit or re-take is appropriate. A re-sit does not need further learning, whereas a re-take does.
The apprentice should have a supportive action plan to prepare for a re-sit or a re-take.
The employer and EPAO agree the timescale for a re-sit or re-take. A re-sit is typically taken within 1 months of the EPA outcome notification. The timescale for a re-take is dependent on how much re-training is required and is typically taken within 3 months of the EPA outcome notification.
Failed assessment methods must be re-sat or re-taken within a 6-month period from the EPA outcome notification, otherwise the entire EPA will need to be re-sat or re-taken in full.
Re-sits and re-takes are not offered to an apprentice wishing to move from pass to a higher grade.
The apprentice will get a maximum EPA grade of pass for a re-sit or re-take, unless the EPAO determines there are exceptional circumstances.
The EPAO must have reasonable adjustments arrangements for the EPA.
This should include:
Adjustments must maintain the validity, reliability and integrity of the EPA as outlined in this EPA plan.
Internal quality assurance refers to how the EPAO ensures valid, consistent and reliable EPA decisions. The EPAO must adhere to the requirements within the roles and responsibilities section:
The EPAO must also:
Affordability of the EPA will be aided by using at least some of the following:
Professional body recognition is not relevant to this occupational apprenticeship.
| Version | Change detail | Earliest start date | Latest start date |
|---|---|---|---|
| 1.1 | Occupational standard, end-point assessment plan and funding band revised | 01/01/2024 | Not set |
| 1.0 | Approved for delivery | 03/02/2020 | 31/12/2023 |
Crown copyright © 2025. You may re-use this information (not including logos) free of charge in any format or medium, under the terms of the Open Government Licence. Visit www.nationalarchives.gov.uk/doc/open-government-licence