V1.1
This document explains the requirements for end-point assessment (EPA) for the facilities management supervisor apprenticeship. End-point assessment organisations (EPAOs) must follow this when designing and delivering the EPA.
Facilities management supervisor apprentices, their employers and training providers should read this document.
A full-time facilities management supervisor apprentice typically spends 18 months on-programme. The apprentice must spend at least 12 months on-programme and complete the required amount of off-the-job training in line with the apprenticeship funding rules.
The EPA should be completed within an EPA period lasting typically 3 months.
The apprentice must complete their training and meet the gateway requirements before starting their EPA. The EPA will assess occupational competence.
An approved EPAO must conduct the EPA for this apprenticeship. Employers must work with the training provider to select an approved EPAO from the apprenticeship providers and assessment register (APAR).
This EPA has 2 assessment methods.
The grades available for each assessment method are below.
Assessment method 1 - project: report with presentation and questions:
Assessment method 2 - professional discussion underpinned by a portfolio of evidence:
The result from each assessment method is combined to decide the overall apprenticeship grade. The following grades are available for the apprenticeship:
The EPA is taken in the EPA period. The EPA period starts when the EPAO confirms the gateway requirements have been met and is typically 3 months.
The EPAO should confirm the gateway requirements have been met and start the EPA as quickly as possible.
The apprentice’s employer must be content that the apprentice is occupationally competent. That is, they are deemed to be working at or above the level set out in the apprenticeship standard and ready to undertake the EPA. The employer may take advice from the apprentice's training provider, but the employer must make the decision. The apprentice will then enter the gateway.
The apprentice must meet the gateway requirements before starting their EPA.
They must:
Portfolio of evidence requirements:
The apprentice must compile a portfolio of evidence during the on-programme period of the apprenticeship. It should only contain evidence related to the KSBs that will be assessed by this assessment method. It will typically contain 10 discrete pieces of evidence. Evidence must be mapped against the KSBs. Evidence may be used to demonstrate more than one KSB; a qualitative as opposed to quantitative approach is suggested.
Evidence sources may include:
This is not a definitive list; other evidence sources can be included.
The portfolio of evidence should not include reflective accounts or any methods of self-assessment. Any employer contributions should focus on direct observation of performance (for example, witness statements) rather than opinions. The evidence provided should be valid and attributable to the apprentice; the portfolio of evidence should contain a statement from the employer and apprentice confirming this.
The EPAO should not assess the portfolio of evidence directly as it underpins the professional discussion. The independent assessor should review the portfolio of evidence to prepare questions for the professional discussion. They are not required to provide feedback after this review.
Gateway evidence must be submitted to the EPAO, along with any organisation specific policies and procedures requested by the EPAO.
The assessment methods can be delivered in any order.
The result of one assessment method does not need to be known before starting the next.
The project assessment method involves the apprentice completing a significant and defined piece of work that has a real business application and benefit. This process may include for example, research, analysis and the completion of tasks or activities to achieve the outcome. The assessment method will have an output at the end of the defined piece of work. The work completed for the project assessment method must meet the needs of the employer’s business and be relevant to the apprentice’s occupation and apprenticeship.
This assessment method has 2 components:
completion of the defined piece of work for the project with a project output
completion of the defined piece of work for the presentation with questions and answers
Together, these components give the apprentice the opportunity to demonstrate the KSBs mapped to this assessment method. They are assessed by an independent assessor.
This assessment method is being used because:
The apprentice must complete a project based on any of the following:
To ensure the project allows the apprentice to meet the KSBs mapped to this assessment method to the highest available grade, the EPAO must sign-off the project’s title and scope at the gateway to confirm it is suitable. The EPAO must refer to the grading descriptors to ensure that projects are pitched appropriately.
The project output must be in the form of project report.
The apprentice must start the project after the gateway. The employer should ensure the apprentice has the time and resources, within the project period, to plan and complete their project.
The apprentice may work as part of a team to complete the project, which could include internal colleagues or technical experts. The apprentice must however, complete their project report and presentation unaided and they must be reflective of their own role and contribution. The apprentice and their employer must confirm this when the project report and any presentation materials are submitted.
The project report must include at least:
The project report must have a word count of 2500 words. A tolerance of 10% above or below the word count is allowed at the apprentice's discretion. Appendices, references and diagrams are not included in this total. The apprentice must produce and include a mapping in an appendix, showing how the output evidences the KSBs mapped to this assessment method.
The apprentice must complete and submit the project report and any presentation materials to the EPAO by the end of week of the EPA period.
The presentation with questions must be structured to give the apprentice the opportunity to demonstrate the KSBs mapped to this assessment method to the highest available grade.
The apprentice must prepare and deliver a presentation to an independent assessor. After the presentation, the independent assessor must ask the apprentice questions about their project, project report and presentation.
The presentation should cover:
The presentation with questions must last 45 minutes. This will typically include a presentation of 20 minutes and questioning lasting 25 minutes. The independent assessor must use the full time available for questioning. The independent assessor can increase the time of the presentation and questioning by up to 10%. This time is to allow the apprentice to complete their last point or respond to a question if necessary.
The independent assessor must ask at least 5 questions. They must use the questions from the EPAO’s question bank or create their own questions in line with the EPAO’s training. Follow up questions are allowed where clarification is required.
The purpose of the independent assessor's questions is:
The apprentice must submit their presentation materials to the EPAO at the same time as the project report - by the end of week 8 of the EPA period. The apprentice must notify the EPAO, at that point, of any technical requirements for the presentation.
During the presentation, the apprentice must have access to:
The independent assessor must have at least 2 weeks to review the project report and any presentation materials, to allow them to prepare questions.
The apprentice must be given at least 2 weeks’ notice of the presentation with questions.
The apprentice may choose to end the presenation early. The apprentice must be confident they have demonstrated competence against the assessment requirements for the assessment method. The independent assessor or EPAO must ensure the apprentice is fully aware of all assessment requirements. The independent assessor or EPAO cannot suggest or choose to end the assessment methods early, unless in an emergency. The EPAO is responsible for ensuring the apprentice understands the implications of ending an assessment early if they choose to do so. The independent assessor may suggest the assessment continues. The independent assessor must document the apprentice’s request to end the assessment early.
The independent assessor must make the grading decision. They must assess the project components holistically when deciding the grade.
The independent assessor must keep accurate records of the assessment. They must record:
The presentation with questions must take place in a suitable venue selected by the EPAO for example, the EPAO’s or employer’s premises. It should take place in a quiet room, free from distractions and influence.
The presentation with questions can be conducted by video conferencing. The EPAO must have processes in place to verify the identity of the apprentice and ensure the apprentice is not being aided.
The EPAO must develop a purpose-built assessment specification and question bank. It is recommended this is done in consultation with employers of this occupation. The EPAO must maintain the security and confidentiality of EPA materials when consulting with employers. The assessment specification and question bank must be reviewed at least once a year to ensure they remain fit-for-purpose.
The assessment specification must be relevant to the occupation and demonstrate how to assess the KSBs mapped to this assessment method. The EPAO must ensure that questions are refined and developed to a high standard. The questions must be unpredictable. A question bank of sufficient size will support this.
The EPAO must ensure that the apprentice has a different set of questions in the case of re-sits or re-takes.
EPAO must produce the following materials to support the project:
The EPAO must ensure that the EPA materials are subject to quality assurance procedures including standardisation and moderation.
In the professional discussion, an independent assessor and apprentice have a formal two-way conversation. It gives the apprentice the opportunity to demonstrate the KSBs mapped to this assessment method.
This assessment method is being used because:
reduces the assessment burden on the apprentice
The professional discussion must be structured to give the apprentice the opportunity to demonstrate the KSBs mapped to this assessment method to the highest available grade.
An independent assessor must conduct and assess the professional discussion.
The purpose of the independent assessor’s questions will be to assess the apprentice’s competence against the following themes:
The purpose is to assess the apprentice’s competence against the following themes:
The EPAO must give an apprentice 10 days' notice of the professional discussion.
The independent assessor must have at least 2 weeks to review the supporting documentation.
The apprentice must have access to their portfolio of evidence during the professional discussion.
The apprentice can refer to and illustrate their answers with evidence from their portfolio of evidence however, the portfolio of evidence is not directly assessed.
The professional discussion must last for 30 minutes. The independent assessor can increase the time of the professional discussion by up to 10%. This time is to allow the apprentice to respond to a question if necessary.
The independent assessor must ask at least 4 questions. The independent assessor must use the questions from the EPAO’s question bank or create their own questions in line with the EPAO’s training. Follow-up questions are allowed where clarification is required.
The apprentice may choose to end the assessment method early. The apprentice must be confident they have demonstrated competence against the assessment requirements for the assessment method. The independent assessor or EPAO must ensure the apprentice is fully aware of all assessment requirements. The independent assessor or EPAO cannot suggest or choose to end the assessment methods early, unless in an emergency. The EPAO is responsible for ensuring the apprentice understands the implications of ending an assessment early if they choose to do so. The independent assessor may suggest the assessment continues. The independent assessor must document the apprentice’s request to end the assessment early.
The independent assessor must make the grading decision.
The independent assessor must keep accurate records of the assessment. They must record:
The professional discussion must take place in a suitable venue selected by the EPAO for example, the EPAO’s or employer’s premises.
The professional discussion can be conducted by video conferencing. The EPAO must have processes in place to verify the identity of the apprentice and ensure the apprentice is not being aided.
The professional discussion should take place in a quiet room, free from distractions and influence. Additional venue requirements include:
The professional discussion should take place in a quiet space, free from distractions and influence. The professional discussion can take place in any of the following:
The underpinning portfolio will have been submitted in line with EPAO requirements and at the gateway and must evidence all of the KSBs mapped to this assessment method. The independent assessor can use the contents of the portfolio to identify discussion areas for the professional discussion.
The apprentice and the independent assessor will have access to their own copies of the portfolio throughout the professional discussion and both can refer to it as needed.
The EPAO must develop a purpose-built assessment specification and question bank. It is recommended this is done in consultation with employers of this occupation. The EPAO must maintain the security and confidentiality of EPA materials when consulting with employers. The assessment specification and question bank must be reviewed at least once a year to ensure they remain fit-for-purpose.
The assessment specification must be relevant to the occupation and demonstrate how to assess the KSBs mapped to this assessment method. The EPAO must ensure that questions are refined and developed to a high standard. The questions must be unpredictable. A question bank of sufficient size will support this.
The EPAO must ensure that the apprentice has a different set of questions in the case of re-sits or re-takes.
The EPAO must produce the following materials to support the professional discussion underpinned by a portfolio of evidence:
The EPAO must ensure that the EPA materials are subject to quality assurance procedures including standardisation and moderation.
Performance in the EPA determines the overall grade of:
An independent assessor must individually grade the project: report with presentation and questions and professional discussion underpinned by a portfolio of evidence in line with this EPA plan.
The EPAO must combine the individual assessment method grades to determine the overall EPA grade.
If the apprentice fails one assessment method or more, they will be awarded an overall fail.
To achieve an overall pass, the apprentice must achieve at least a pass in all the assessment methods. To achieve an overall distinction, the apprentice must achieve a distinction in all the assessment methods.
Grades from individual assessment methods must be combined in the following way to determine the grade of the EPA overall.
If the apprentice fails one assessment method or more, they can take a re-sit or a re-take at their employer’s discretion. The apprentice’s employer needs to agree that a re-sit or re-take is appropriate. A re-sit does not need further learning, whereas a re-take does. The apprentice should have a supportive action plan to prepare for a re-sit or a re-take.
The employer and the EPAO should agree the timescale for a re-sit or re-take. A re-sit is typically taken within 2 months of the EPA outcome notification. The timescale for a re-take is dependent on how much re-training is required and is typically taken within 4 months of the EPA outcome notification.
If the apprentice fails the project assessment method, they must amend the project output in line with the independent assessor’s feedback. The apprentice will be given 4 weeks to rework and submit the amended project report.
Failed assessment methods must be re-sat or re-taken within a 6-month period from the EPA outcome notification, otherwise the entire EPA will need to be re-sat or re-taken in full.
Re-sits and re-takes are not offered to an apprentice wishing to move from pass to a higher grade.
The apprentice will get a maximum EPA grade ofif pass they need to re-sit or re-take one or more assessment methods, unless the EPAO determines there are exceptional circumstances.
The EPAO must have reasonable adjustments arrangements for the EPA.
This should include:
Adjustments must maintain the validity, reliability and integrity of the EPA as outlined in this EPA plan.
Internal quality assurance refers to the strategies, policies and procedures that an EPAO must have in place to ensure valid, consistent and reliable EPA decisions.
EPAOs for this EPA must adhere to the requirements within the roles and responsibilities table.
They must also appoint independent assessors who:
appoint independent assessors who have knowledge of the following occupational areas - facilities management.
Affordability of the EPA will be aided by using at least some of the following:
This apprenticeship is not aligned to professional recognition.
| Version | Change detail | Earliest start date | Latest start date |
|---|---|---|---|
| 1.1 | Occupational standard, end-point assessment plan and funding band revised | 01/01/2024 | Not set |
| 1.0 | Approved for delivery | 17/02/2017 | 31/12/2023 |
Crown copyright © 2025. You may re-use this information (not including logos) free of charge in any format or medium, under the terms of the Open Government Licence. Visit www.nationalarchives.gov.uk/doc/open-government-licence